+86 13827272341

Sealing machine fundamental problems and maintenance

Release date:2023-08-10

The automatic sealing machine equipment opens the power supply, the motor starts, until the sealing box enters the automatic sealing machine through the conveyor belt, when the left and right movement of the automatic sealing machine encounters the tape, the left and right movement moves, and the sealing actions such as taping, smoothing and blocking are completed; The automatic sealing machine uses tape to seal the carton, which is economical, fast and easy to adjust. The sealing action of the automatic sealing machine can be completed at one time. If the printing tape is selected, the product image can be improved.


We all know that any equipment needs timely maintenance in the process of use, so that we can ensure the normal operation of the machine, but also to extend the service life of the machine. So taking care of the machine is also a very important thing, but there will be many people do not know how to take care of the machine, and where to start, then, the next small series will talk with you: how to maintain the active automatic sealing machine?


1, sealing machine exhaust leakage: switch valve ring or switch seat ring damage or piston ring damage, change the ring;


2. Air leakage at the piston rod of the sealing machine: the bottom ring of the main body is damaged, and the ring should be replaced at this time;


3, air leakage at the trigger: switch valve ring or switch seat ring is damaged, change the ring;


4. The transmission ring is loose and cannot be located: the plastic steel bar and the transmission spring are not elastic. Remove the plate assembly and reinstall the spring tip or replace the plastic steel bar and transmission spring;


5. The clamping action of the sealing machine is too slow or the clamping stroke is lack: the bolt is loose, the front buckle or the inner piece of the plate is worn. At this point, the bolt can be tightened, paying attention to the correct position of the front buckle. It can also change the front buckle or the inner piece of the plate, after completing the above action, test its function, if the stroke is too short, fine tune the front buckle shaft upward, if the action is slow, fine tune the front buckle shaft downward.


Dongguan Zonbot Intelligent Technology Co., Ltd Copyright © 2023
Gmap】【Bmap